05 Feb. 21
Installing a New Garbage Disposal in Granada Hills
1. Detach the p-trap as well as the horizontal expansion pipe.
Big channel-lock pliers or a pipe wrench job well to loosen the nuts holding the pipes together. When both links are complimentary, eliminate the components. You might want to clean up the horizontal drain pipeline to get rid of any type of feasible clog. (This is not essential in brand-new building.).
2. Disconnect the down drainpipe.
Using huge channel-lock pliers, detach the down drainpipe originating from the sink and also the link that attaches it to the p-trap. When both connections are cost-free, remove the components.
3. Unscrew the large nut.
Unscrew the large nut that holds the filter in place underneath the sink. Eliminate the strainer body.
4. Tear off the breeze ring and clean off the old plumbing technician’s putty.
Utilizing a flathead screwdriver, loosen the 3 screws on the placing assembly and tear off the breeze ring. Wipe the old plumbing technician’s putty that borders the edge of the drain opening.
5. Set up the new sink flange.
Area a 1/2″ rope of plumber’s putty around the drain opening in the sink. Go down the brand-new sink flange into the drain opening as well as press it into location. Putting a weight, such as your garbage disposal, in addition to the sink flange will certainly aid hold the sink flange in place while installing it to the sink. To stay clear of scratching your sink or the flange, place a towel in between the sink surface and also the weight.
6. Install gasket and flanges.
From under the sink, slide the fiber gasket, back-up flange and installing flange over the sink flange. Hold these pieces in place.
7. Slip on the mounting and also break rings.
Next, slip on the mounting ring as well as break ring. Tighten the 3 installing screws, at the same time tightening each screw a few turns at once until the installing setting up is evenly and firmly seated against all-time low of the sink.
8. Remove the dish washer ko plug.
If making use of a dish washer, you will need to tap out the dishwasher ko plug. Lay the garbage disposal on its side and utilize a screwdriver and also hammer to tap it out. Next, eliminate the loose knockout plug from inside the garbage disposal.
9. Connect the electrical.
Hardwired Unit:.
Transform the garbage disposal over and also get rid of electric cover plate. Pull out cords. Place cable television adapter (not included) as well as run electric cable via gain access to hole on base of garbage disposal. Tighten cord adapter. Press cords right into garbage disposal (do not displace cardboard shield) as well as change electric cover plate.
If you have a hardwired device as well as you’re seeking to connect a cable, you will require a power cord kit.
Corded Unit:.
For a garbage disposal with a factory-installed cord, just plug in to the outlet under your sink after completing the remainder of the steps.
10. Hang the garbage disposal.
Hang the garbage disposal by straightening the three mounting tabs with the slide-up ramps on the mounting ring. Holding the garbage disposal in place, turn the lower placing ring up until all 3 tabs are secured right into the mounting setting up.
11. Insert the discharge tube.
Place the discharge tube right into the discharge coupler, after that move the clamp over the discharge tube and also placement it in the groove on the rubber tailpipe coupler.
12. Line up the discharge tube with the drain pipe.
Revolve the garbage disposal to ensure that the discharge tube is aligned with the drain catch. If the discharge tube is too long, cut off as much of television as required. If it is as well brief, you can purchase an expansion. If you are attaching the garbage disposal to a dishwasher, it may be linked with an air space. Make use of a pipe clamp to affix the drainpipe pipe to the dishwashing machine inlet.
13. Lock the garbage disposal in place.
Now that whatever is installed as well as in position, secure the garbage disposal to the sink placing assembly making use of the wrench that included the system. Put the Quiet Collar Sink Baffle right into the sink opening by pushing it right into the sink until it breaks right into location.
14. Evaluate the garbage disposal.
Examination for leaks at the sink flange, dishwashing machine, tail-pipe and also installing setting up connections. Lastly, turn on the electrical breaker to examine its operation. Appreciate your brand-new garbage disposal!
Garbage Disposal Installation in Granada Hills
Setting Up a Replacement Garbage Disposal in Granada Hills