Faucet breakdowns are a more common problem than we think. Its causes can be very varied, but it is not always necessary for a technician to locate where the fault is. In any case, if we want to avoid them or understand what to do when they appear, it is best to understand what the main causes are. We are going to learn them in this article.
Why do faucets and sink stop working?
To prevent faucet breakdowns, as we will see below, it is extremely important to take specific procedures. Preventative measures and great care can save us many frustrating issues. However, on many occasions, faucets failures arise due to their own usage and the passage of time.
Absence of upkeep
As we already announced, not performing proper upkeep can trigger faucet failures. Given that these remain in constant contact with the water and this brings sediment, aspects such as lime can cause problems.
Inside the diffuser there is a kind of grid that is where the water is filtered. With using the tap gradually, the amount of particles increases, to the point of obstructing it. It is at this time when the breakdown takes place, as the water brings out trouble.
To resolve this faucet failure, we simply have to loosen the piece and extract the grate. We can clean it or leave it taken in vinegar to eliminate all the embedded dirt. Or utilize specific items for cleansing.
Lime
Lime is the cause of many faucet failures. One of them is a water leak. This can range from a persistent drip at the faucet outlet to a major leak. The issue is that the stopcock does not close properly.
The build-up of lime forms stones, which by preventing the joint from closing, leaves a free hole through which the water permeates. These faucet failures are fixed by dismantling them and cleaning up the rubber seals It is suggested that an expert plumbing professional do it.

Degeneration of the rubbers or seals.
Another of the most typical reasons for faucet failures is the degeneration of the parts that compose them. Those that are most easily harmed are the rubber of the tap shaft or the gasket. They can be replaced by brand-new ones without additional complication.
To determine that this is the cause, a leak needs to appear. When this is produced by the typical outlet of the tap, the issue is usually due to the rubber. We will close the water tap, dismantle them and alter it for a new one.
When the drip appears in the location of the thread, we can first attempt to try to change it and see if the issue disappears. If it persists, we will continue to draw out the nut and alter the gasket. It is among the most common faucet failures. It can also be due to the same piece when the drip is in the area that joins it with the wall.
The tap is screwed on incorrectly
Another of the most common faucet failures is simply that one of the parts is incorrectly positioned. If we have assembled it ourselves and we are not qualified professionals, or somebody has not been careful enough, it is possible that something has been incorrectly fitted and because of that it leaks from a few of its parts.
Poor quality faucets and sinks
Low-cost is normally expensive, and if our tap is of very poor quality, it is likely that it will begin to give us problems earlier than expected. These faucet failures have the only option to get product that has warranties.
we are dedicated to products of the highest quality and we send our items to the strictest controls. In addition, we provide a 5-year warranty on all our ranges.
Leading sink and faucet trends for 2021 in Valley Village