Faucet breakdowns are a more typical issue than we think. Its causes can be very diverse, but it is not constantly essential for a specialist to find where the fault is. In any case, if we wish to prevent them or know what to do when they appear, it is best to understand what the main causes are. We are going to know them in this short article.
Why do faucets and sink stop working?
To prevent faucet breakdowns, as we will see below, it is very important to take particular procedures. Precautions and good care can save us numerous irritating problems. However, on numerous occasions, faucets failures arise due to their own usage and the passage of time.
Absence of upkeep
As we already introduced, not performing proper maintenance can trigger faucet failures. Considering that these remain in continuous contact with the water and this carries sediment, factors such as lime can trigger issues.
Inside the diffuser there is a kind of grid that is where the water is filtered. With using the tap gradually, the amount of particles increases, to the point of obstructing it. It is at this time when the breakdown takes place, as the water comes out with difficulty.
To solve this faucet failure, we just have to loosen the piece and extract the grate. We can wash it or leave it taken in vinegar to eliminate all the embedded dirt. Or use particular products for cleaning.
Lime
Lime is the cause of numerous faucet failures. Among them is a water leak. This can vary from a consistent drip at the faucet outlet to a major leak. The problem is that the stopcock does not close appropriately.
The accumulation of lime forms stones, which by avoiding the joint from closing, leaves a free hole through which the water permeates. These faucet failures are solved by disassembling them and cleaning up the rubber seals It is recommended that a professional plumbing technician do it.

Deterioration of the rubbers or seals.
Another of the most common causes of faucet failures is the degeneration of the parts that compose them. Those that are most quickly harmed are the rubber of the tap shaft or the gasket. They can be replaced by new ones without additional complication.
To determine that this is the cause, a leak needs to appear. When this is produced by the normal outlet of the tap, the problem is generally due to the rubber. We will close the water tap, disassemble them and change it for a new one.
When the drip appears in the location of the thread, we can initially attempt to attempt to adjust it and see if the issue vanishes. If it continues, we will continue to extract the nut and alter the gasket. It is among the most typical faucet failures. It can also be due to the exact same piece when the drip remains in the location that joins it with the wall.
The tap is screwed on incorrectly
Another of the most common faucet failures is just that one of the parts is incorrectly placed. If we have assembled it ourselves and we are not qualified experts, or somebody has not been careful enough, it is possible that something has been mistakenly fitted and because of that it leaks from some of its parts.
Poor quality faucets and sinks
Inexpensive is generally expensive, and if our tap is of really poor quality, it is likely that it will start to offer us issues earlier than assumed. These faucet failures have the only option to acquire material that has guarantees.
we are devoted to materials of the highest quality and we send our products to the strictest controls. In addition, we provide a 5-year service warranty on all our ranges.
Typical issues of kitchen sink faucet from hose design in Burbank
Top sink and faucet trends for 2021 in Burbank